March 11, 2015

Power Trak

PowerTRAK

Drill  Powered Swimming Pool Cover System

powertrak-7 (1)

The PowerTRAK  Pool Cover System is an engineering masterpiece. The PowerTRAK was designed for smaller pools where getting power to the swimming pool is not practical, or a mid range auto cover is desired.

The PowerTRAK Pool Cover System is built for medium to small size pools and spas, and operates using a rechargeable Drill instead of 110 or 220 Volt power. This means it can be added to almost any existing pool or new construction and no added electrical, conduit or electrical permits are required. The PowerTRAK is ASTM Safety Certified, extremely convenient, easy to run, very low maintenance, and is perfect for locations where no power is available at the pool.

DSC_0026 (1)

To operate the PowerTRAK, just place the drill drive socket over the specially designed drive shaft in our patented gear reduce motor (there is a gear reducer motor located on each side of the mechanism). There are two (2) gear reducer motors, one on each side of the pool, one is used to open the cover and the other is used to close the cover.

Tom-Pavlidis01a

The PowerTRAK is ideal for existing pools and can be either mounted on the deck and covered with our specially designed End Housings or our full Vinyl Bench. No matter how you mount and cover the unit, on new or existing pools, the PowerTRAK does not require any electrical preparation.

powertrack

The Vinyl Bench is the perfect solution for covering the PowerTRAK system and the pool cover fabric. With the Vinyl Housing, the entire cover fabric, including the leading edge, retracts into the bench cavity when the pool is in use.

DSC_0022

The Vinyl Bench is available in tan or white and each one is custom built to fit your pool and cover system…they can also be built to accommodate a diving board.

Call Pool Infinity Pool Covers today for your PowerTrak at(435- 767-7222)